CONFIDENTIAL
DOC-USR-0010-09
___________________________________________________________________________________________
Z3 Technology, LLC
♦
100 N 8
th
ST, STE 250
♦
Lincoln, NE 68508-1369 USA
♦
+1.402.323.0702
27
10.0
RUNNING THE CODE YOU BUILT ON THE BOARD
There are two ways to take the image files you built in Section 3 and run them on the board: (1) Updating
the image file, and (2) Setting up NFS/TFTP to link to your development PC.
10.1
Method 1: Updating the Image File
(1)
Run the Web Interface (Steps (1)-(9) in Section 5).
(2)
Click on the “System Setup Tab”.
(3)
In the System Setup Tab, click “update device firmware”:
*Note:
If “update device firmware” is greyed out (as it is in the figure above), it is because the
encoder or decoder is running. If you click “Stop” at the bottom of the screen, then “update device
firmware” will become active and you can then click it.
Figure 18 Updating the Device Firmware from the Web Interface
Click here
