Z-World OP7100, Руководство пользователя

Страница: 28 / 122

OP7100 28 s Hardware
watchdog timer is
hitwd
. To hold the watchdog timer at bay, make a call to
hitwd
in a routine that runs periodically at the lowest software priority level.
A program can read the state of the
WDO
line with a call to
wderror
. This
makes it possible to determine whether a watchdog timeout occurred. The
following sample program shows how to do this when a program starts or
restarts.
main(){
if( wderror() ) wd_cleanup();
hitwd();
...
}
Power Shutdown and Reset
When VCC (+5 V) drops below V
MIN
(between 4.5 V and 4.75 V), the
ADM691 supervisor asserts
/RESET
and holds it until VCC goes above
V
MIN
and stays that way for at least 50 ms. This delay allows the system’s
devices to power up and stabilize before the CPU starts.
PFI “Early Warning”
When
PFI
drops below 1.3 V ± 0.05 V (i.e., DCIN drops below ~10 V),
the supervisor asserts
/NMI
(nonmaskable interrupt), and allows the
program to clean up and get ready for shutdown. The underlying assump-
tion here is that
PFI
will cause the interrupt during a power failure before
the ADM691 asserts
/RESET
.
In order to improve the performance of the power-failure NMI circuit, we
have added some hysteresis to the power-failure comparator by adding a
resistor, R34, between the comparator input and output pins. R34 can be
found on the 175-0196 and the 175-0211 versions of the OP7100. The
hysteresis prevents the comparator from switching rapidly—and therefore
generating multiple interrupts—when the input voltage is falling slowly.
Once the comparator switches (DC IN falls to approximately 8.5 V), this
feedback holds the input (PFI) low and prevents further interrupts from
being generated. At this point, the 5 V regulator still has sufficient voltage to
keep the processor operating, so that an interrupt service routine can
perform shutdown tasks and “tidying up” before the Vcc line fails. The
comparator will not turn the output (PFO) high until DC IN has risen to
about 9.2 V. The hysteresis will also help prevent any system oscillation in
adverse power supply/loading situations.
The voltage at which the power-failure interrupt occurs may be changed by
adjusting the values of R29 and R30, which are shown in Figure 3-3. To
calculate the values of these components, let V
L
be the voltage at which
PFO turns off as DC IN falls, and let V
H
be the voltage at which PFO turns
on as DC IN rises.