* Tamper Report:
When the tamper is pressed, the device will into the alarm state. In
that state, if tamper is released, the yellow LED will light on and the
device will unsolicited to send the report to the nodes in the group 1.
Notification Report (V4)
Notification Type: Home Security (0x07)
Event: Tampering. Product covering removed (0x03)
Sensor Binary Report (V2)
Sensor Type: Tamper (0x08)
Sensor Value: 0xFF
Notice :
When the event triggered, the device will report the messages
to the nodes in the group 1. The messages also include the tamper
status.
Power Up Procedure
* NWI
When the device power on, the device will check is it already adding to
the network? If doesn't, press the button to start the NWI mode. Until
timeout or the device successful to inclusion by controller. NWI mode
can be aborted by pressing the button 3 times.
* Wake
When the device power on, the device will wake about 20 seconds. In
this duration, the controller can communicate with the device. Normally
the device is always sleeping to save the battery energy.
Over The Air (OTA) Firmware Update
The device support the Z-Wave firmware update via OTA.
Let the controller into the firmware update mode, and then press the
button once to start the update.
Please don't remove the battery
, otherwise it will cause the
firmware broken, and the device will no function.
After update finish, it is recommended that the user power up the
device.
Caution
: After remove the battery, please wait about 30
seconds, and then re-install the battery.
Security Network
The device support the security function. When the device included
with a security controller, the device will auto switch to the security
mode. In the security mode, the follow commands need using Security
CC wrapped to communicate, otherwise it will not response.
COMMAND_CLASS_BATTERY
COMMAND_CLASS_NOTIFICATION_V4
COMMAND_CLASS_ASSOCIATION_V2
COMMAND_CLASS_CONFIGURATION
COMMAND_CLASS_SENSOR_BINARY_V2
COMMAND_CLASS_WAKE_UP_V2
Test Alarm
Test the sensor by pushing firmly on the test button for around 2
seconds until the horn sounds, the sound pattern is 3 beeps, pause,
and then 3 beeps with red LED flashing continuously and rapidly, and
the controller will receive Smoke alarm test notification. If the Smoke
Sensor beeps three with yellow LED flashing three times in 43 seconds,
it indicates the Smoke Sensor is not working properly, it requires to be
repaired.
This is the only way to make sure that the Smoke Sensor device is
working properly. If the device fails to test properly, have it repaired or
replaced immediately. If you suspect that your Smoke Sensor does not
3
