Thanks to its slim design the AEOTEC Door/Window Sensor 7 Pro can be installed unflashy on every
window. The sensor just has to be installed on the window casement. Additionally, there has to be a slim
magnet installed closely to the sensor at the window frame. By using a patented method the sensor can
reliably detect the exact position of the window.
With the potential free input, the Door/Window Sensor can also include other sensors in your Z-Wave
system. For that, the binary sensor is connected to the potential free input of the sensor. Besides sensors,
there can also be connected momentary switches, which control scenes in your gateway.
Tripple clicking the tamper button includes (adds) and excludes (removes) the device.
A single click on the button will wake up the device. The device supports the Z-Wave Security S2
framework with authenticated and unauthenticated network keys. Please follow the instructions on the
central controller when including. The device also supports Smart Start.
Prepare for Installation / Reset
Please read the user manual before installing the product.
In order to include (add) a Z-Wave device to a network it
must be in factory default state.
Please make
sure to reset the device into factory default. You can do this by performing an Exclusion operation as
described below in the manual. Every Z-Wave controller is able to perform this operation however it is
recommended to use the primary controller of the previous network to make sure the very device is
excluded properly from this network.
Reset to factory default
This device also allows to be reset without any involvement of a Z-Wave controller. This procedure should
only be used when the primary controller is inoperable.
Once Cover is removed and the tamper switch is tripped, push the tamper for 5 seconds until the RED
LED blinks once. Then release tamper and push it again for 5 seconds while the RED LED is blinking until
the GREEN LED blinks once.
Safety Warning for Batteries
The product contains batteries. Please remove the batteries when the device is not used. Do not mix
batteries of different charging level or different brands.
Installation
The sensor can be mounted either on the moving part or on the fixed part of a door or a window.
Mounting can be accomplished either using the tape by peeling off the protection foil or using two
screws with the holes inside the battery compartment. If the tilt detection on a window (only normal
windows, no roof windows) shall be used the sensor device must be placed on the moving part of the
window and the magnet on the window frame.
The sensor comes with two types of magnets:
Содержание Aeotec 7 Pro
Страница 1: ...Door Window Sensor 7 Pro ...