11
CONFIGURATIONS
Doc# 27-0044UM Rev B Issued 7/13/2012
3.7 REMOvING A POwER SUPPLY MOdULE
NOTE: If one of the power supply modules is
removed, then the system will still operation
with only one remaining power supply.
WARNING: A failed power supply will
be identified by an audible alarm. This
alarm may vary based on your specific
motherboard.
3.8 INSTALLING A NEw POwER SUPPLY MOdULE
NOTE: Different power supply options are
available. Step 3 (below) is an example of
dual redundant power supplies with military
connectors. Step 4 (below) is an example
of dual redundant power supplies with IEC
connectors.
1. Using your fingers, twist to remove both
screws from the rear top plate of the Power
Supply module
2. Insert a finger into the handle and begin
to pull the module from the station.
3. Gently but firmly continue to pull
th e Power Supply module out of the
ZX3 station .
1. Carefully position the Power Supply module
to the docking bay.
3. Push the unit all the way into the ZX3
station and verify the rear of the Power
Supply module is flush with the casing.
4. Using your fingers, twist to refasten
the security screws of the Power Supply
module to the ZX3 station.
2. Using your finger inserted into the
handle on the rear of the Power Supply
Module, firmly push the module into the
docking bay.
