5
5. The last OBD-II plug on the T-harness can be put back into the
vehicle’s OBD-II holder where you removed the OBD-II port from in
step 1.
4. Connect the white plug from the T-Harness into the green Star
Board. For the 2018-2020 Dodge Challengers the Star Board is
located on the passenger’s side to the right of the glove box. If you
have multiple green Star Boards then you will need to use the one
with the white plugs and yellow wires. You can use any open port.
3. Connect the female end of the T-Harness into the vehicles OBD-II
port that you removed in step 1.
2. Connect the Z-Flash to the
T-Harness OBD-II port where
the green and yellow plugs
exit from.
1. Using the two clips on the
side of the OBD-II port,
squeeze and push the
port forward to push it out
of the holder.
Connects to Z-Flash
Replaces factory
OBD-II Port
Connects to Star Board
Connects to factory OBD-II port
The Z-Flash T-Harness will work with 2018-2020 Dodge
Challenger. This harness prevents you from having to access the
security gateway and install a Gateway Bypass Module. Once your
T-Harness is installed you will not need a Z-Flash Gateway Bypass
Module. The T-Harness does not need to be removed when
getting the vehicle serviced. The T-Harness also acts as a splitter
and leaves room for an additional OBD-II device to be connected
to the vehicle.
2
2
1
1
3
3
5
4
4
Quick Reference Guide
T-HARNESS INSTALLATION FOR:
2018-2020 Dodge Challenger
