10
Live Menu Settings
This section explains how to use the Tazer JL Mini’s live functions – these are
activated with the same button presses as the Settings Menu, but
while the engine is
RUNNING
. These features
will only work if the Tazer JL Mini remains plugged in
. Please
note that AutoSport, Trac Kill, and StMode will be enabled after initial setup.
• Light Show:
This is one method of activating
the light shows. Selecting this will activate
the first show, unless ZPU was used to
change the startup show. There are 9 light
shows – you can toggle through all 9, then
back to OFF.
• Set In-Motion Nav:
If set ON, this adds the
ability for address info to be entered into the
navigation system while vehicle is moving.
This is for the PASSENGER to use. It may be
illegal for the driver to use the navigation
system to enter information while the vehicle
is in motion. It is recommended to leave
this setting OFF, enabling it only when you
need to use it, as it can cause an occasional
radio reboot right after engine start-up. This
will automatically be disabled if TurnCAM is
enabled.
• TurnCAM:
If enabled, will automatically turn
on the backup camera if the turn signals are
being used. When this is enabled, In-motion
nav will be disabled.
• Hood Alarm:
Turn hood alarm on/off.
Requires that Set Panic is enabled
• Dark Mode:
If enabled, turn off all exterior
lights and dash, radio, and shifter lighting.
Selecting again, advancing to next menu
item, pressing “screen off”, or driving over 5
mph will automatically cancel this mode.
• Video:
If selected, will turn on backup camera
input.
• VAC or BOOST:
If selected, will display the
Vacuum/Boost Gauge on the EVIC
• 0-30 Timer:
When the vehicle is stopped,
this display will change to “start 30”. As soon
as the vehicle starts moving, the display will
change to “go to 30” and the timer starts.
When the vehicle reaches 30MPH, the time
will be displayed.
• 0-60 Timer:
When the vehicle is stopped,
this display will change to “start 60”. As soon
as the vehicle starts moving, the display will
change to “go to 60” and the timer starts.
When the vehicle reaches 60MPH, the time
will be displayed.
• Winch RPM:
Use left arrow and /-
buttons to adjust Winch Mode RPMs, 1300-
200RPM. Use left arrow and cruise on/off to
save the new setting.
• Display Tazer JL Mini Firmware Revision:
Displays the Tazer JL Mini’s current firmware
version: “TZ JL: x.x.x.” (ie “TZJL:11.2.0”)
