YUSHI PM-5 Series, Руководство по эксплуатации

Страница: 7 / 15

MINIMUM OF B SCAN : Set the minimum thickness of the B scan.
MAXIMUM OF B SCAN : Set the maximum thickness of the B scan.
RECTIFICATION MODE : RF+ and half +. RF+ describes the complete
echo waveform; half + means putting off the half
–
echo and only left
the half + echo.
3.4 Half-Wave Filling
RECTIFICATION WAVEFORM: outline mode and filled mode.
RESOLUTION: Set the decimal digits of the measurement result. Metric
of X.X, X.XX and X.XXX; imperial of X.XX,
，
X.XXX and X.XXXX.
UPDATE RATE: Update the rate of measurement result. Optional 4Hz,
8 Hz and 16Hz.
LANGUAGE: Set the interface language.
UINTS: Selectable units of mm/inch.
AUTO POWER DOWN: The device will be automatic power off if no key
presses or measurements occur for set 5 minutes, 10 minutes or 20
minutes.
DELETE ALL FILES
–
Empty the thickness readings and waveforms
of all files.
DEFAULT SET UP
–
Set all parameters to their factory default values.
3.3 Normal Mode
PM-5 series have three measuring interface: normal mode, A-scan
interface, B-scan interface. And there are three display modes of normal
interface: Thickness value mode, Difference/rate-of-reduction
measurement mode, MAX. /MIN. measurement mode. Select in the
“
VIEW MODE
”
of CONFIGURATION.
When the probe and the object are not completely coupled, the letters in
the various interfaces are in GREEN, when properly coupled, they are
displayed in WHITE color and when the either the upper or lower limited
are exceeded, the letters are displayed in RED color.
THICKNESS VALUE MODE: the acquiescent opening interface. This
interface mainly shows the present thickness value with large digits.
3.5 Normal Mode Interface
1
—
the present thickness value 2
—
probe types, gain degree, Pulse
Echo measuring mode, measuring units 3
—
material velocity 4
—
battery power display 5
—
A-scan interface
DIFFERENCE/RATE-OF-REDUCTION MODE: this interface displays
the currently measured and a nominal thickness input by user, the
difference between the currently measured thickness and the nominal
thickness and the ratio between the difference and the nominal
thickness. Before using this mode, presetting the nominal thickness is
needed.
11 12