Yunmai YMFG-B563, Руководство пользователя

Страница: 20 / 22

FrequentLy Asked Questions
TrouЫeshooting of massage Gun Operation
Fault description TrouЫeshooting
The massage head slides out Check whether the massage head is installed in place
and falls
The product cannot Ье started Check whether the power is sufficient (if the product
has not Ьееп used for а long time, please charge it
for more than 8 hours)
Тhе product cannot Ье charged Check whether the charging connector and power
supply are plugged in place
The product stops suddenly
This phenomenon is normal as it is caused Ьу the
after 10 minutes of contin-
setting for long-term operation protection, which
-uous operation
switches from operation to standby mode.
And the product сап Ье restarted through short pressing
The product stops working
This phenomenon is normal as it is caused Ьу the
setting for abnormal operation protection, which
after the massage head switches from operation to standby mode.
encounters the phenomenon
And the product сап Ье restarted through short
of locked-rotor
pressing.
ReasonaЬle use of the product сап effectively extend its service
life
Suggestions:
• Do not throw or cast the product during use.
• Кеер the maximum continuous service time lower than 30 minutes.
• Please charge the product every other month if it is not used
for а long time.
37
Caution
Changes or modifications not expressly approved Ьу the party
responsiЫe for compliance could void the user's authority to
operate the equipment.
Note:
This equipment has been tested and found to comply with the
limits for а Class В digital device, pursuant to Partl 5 of the FCC
Rules. These limits are designed to provide reasonaЬle protection
against harmful interference in а residential installation.
This equipment generates, uses, and сап radiate radio frequency
energy, and if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is по guarantee that interference will not occur
in а particular installation. lf this equipment does cause harmful
interference to radio or television reception, which сап Ье
determined Ьу turning the equipment OFF and ON, the user is
encouraged to try to correct the interference Ьу one or more of
the following measures:
• Reorient or relocate the receiving antenna
• lncrease the separation between the equipment and receiver
• Connect the equipment into an outlet оп а circuit different from
that to which the receiver is connected
• Consult the dealer or an experienced radio / ТV technician for
help.
38