Find the locking clip which is located in front of the
mounting slot.
Step 2.
Press and hold the locking clip and push the E10T
forward (the direction shown by the arrow).
Binding the E10T
Step 1.
Switch on the ST16S and the H520 aircraft.
Step 2.
Tap the [
] on the top right corner on the main
interface of ST16S.
Step 3.
Tap the serial number of the E10T when the following
window pops up. (If multiple Yuneec UAS are used,
check the ID number on the side of each camera to
assure correct camera selection/binding).
