Revised 03-11-10
YUNCA FUZiON FEBRUARY 2010
Page 10 of 19
AUTO FUNCTION CONTINUED:
Once the times are set, press the grey
AUTO SET
button
and leave the
remote near, but not on,
the fire
or the fire will not operate automatically. When the
AUTO SET
button is
pressed you will hear a long beep. When the fire is turned off the green light on the front control panel (Page
11, FIG 4) will flash slowly to show AUTO is set, and you will see the AUTO symbol display on the LCD
screen of the remote control unit.
IMPORTANT
:
Press
AUTO SET
button again to cancel the auto feature or the fire will continue to
operate to the automatic settings,
even if the remote is “off”
.
NOTE
– Even when
AUTO SET
is activated (i.e. the display shows
AUTO
on the remote and the
green light on the fire is flashing) you can continue to operate the fire (i.e. turn it on and off, change
mode and heat output) without affecting the automatic feature settings. You are effectively
temporarily overriding the automatic control, e.g. if you wish to stop the fire running at an earlier
time.