Yulong D200, Руководство пользователя, Страница: 6 / 13

1
2
3
4
5
6
LCD display shows the modes. Auto dim after 5 second idle.
Input selection. Cycles between Spdif, toslink, aes, usb when pushed. Sampling frequency will be displayed on LCD when
signal is locked. DSD logo will be shown when a valid DSD signal is detected.
Digital filter mode selection. The default sharp mode has a flat response. When the LED lights up, it is in slow mode which
has a slow roll off in high frequency (DSD mode
50KHz - 70KHz filter.)
Jitter eliminator selection. It is bypassed when LED lights up, and sound is tend to slower and softer. When it is on, the
sound tend to more focus. However depends on the equipments, you may not hear a difference.
Headphone out.
!!!
Warning: The headphone jack on D200 is VERY tight, please make sure the headphone plug is fully inserted. In
case of not fully inserted, the left and right outputs are shorted and will damage the headphone amplifier! The
short circuit can not prevent this situation!!! We don't honor warranty to damage under this situation!!!!
!!!
Warning: Please turn the volume to minimum before connecting or turning on equipments. It may sound
dangerous loud!
Tips: When in pure DAC mode, the headphone amplifier is shut off - however you may still hear minor sounds
from the headphone jack. It is normal.
Volume control, turn to change output level in 80 steps. It controls all outputs. Press the volume knob for 1 second to
change D200 into pure DAC mode. Volume control and headphone amplifier are bypassed in pure DAC mode.
!!!
Warning: D200 outputs a full scale signal in pure DAC mode. You must have a volume control in your system,
otherwise the output level could be dangerous high, and might permanently damage your equipment and hearing!!!!
You may also face angry family members, neighbors and pets! We don't response to any damage under such
condition.
13
D200 210*140mm P13