•
Direct your NVMT 5 device at an object at a distance approximately 100 yards. Adjust the
eyepiece and objective lens diopter setting to focus the unit by rotating the eyepiece (4) and objective lens (5).
After the adjustment, do not rotate the eyepiece irrespective of the distance and other conditions.
•
Direct your NVMT 5 device at the subject to be viewed and adjust the final focus by rotating the
objective lens (5) focusing ring until the image quality is optimal.
•
The Green LED indicates that the light amplifier unit is on. The Red LED indicates that the IR
illuminator is on.
Do not store your NVMT 5 when any of the indicators are lit. When you finish using your NVMT 5
device, turn off the IR illuminator and light amplifier. Return the lens cap to the objective lens.
B. RIFLESCOPE (See Figure 2)
•
Unscrew the eyepiece of the monocular (1) by rotating it counterclockwise.
•
Screw the eyepiece of the riflescope (2) clockwise.
•
Fasten Red Dot Laser Pointer to the Riflescope Mounting Bracket (3) by clamp (6) and two
screws (7).
•
Fasten the monocular to the Riflescope Mounting Bracket (3) by means of two screws ( 4)
•
Fasten the Riflescope Mounting Bracket (3) on the rifle by two screws (8).
•
Fasten the Laser Pointer “ON” button (9) to the fore-end of rifle stock.
•
Before activating the device come into dark area.
•
Remove the objective lens cap (10) and store in a pocket provided.
•
Activate the device by pushing the “ON” button (12).
•
If you wish to test your night vision device in a lighted area, be sure the lens cap is in place prior
to pressing the “ON” button. The lens cap has a pinhole opening to admit a small amount of light for testing
purposes.
•
If the subject to be viewed is in a completely dark area, including low light shadow areas, activate
the infrared illuminator by pressing the IR Button (11) located next to the “ON” button.
•
Direct your NVMT 5 device at an object at a distance approximately 100 yards. Adjust the
eyepiece and objective lens diopter setting to focus the unit by rotating the eyepiece (2) and objective lens (10).
After the adjustment, do not rotate the eyepiece irrespective of the distance and other conditions.
•
Direct your NVMT 5 device at the subject to be viewed and adjust the final focus by rotating the
objective lens (10) focusing ring until the image quality is optimal.
•
After installation of the riflescope to the rifle it is necessary to carry out adjustment/ranging fire.
Unscrew the cover (13) and adjust the aiming position of the dot by turning the screws (14). Zeroing-in the
Laser Pointer is identical to adjusting a regular rifle scope. Screw the cover (13).
