Yukon Eagle LW-000 Series, Руководство пользователя

Страница: 7 / 28

door handle
Install door handle as follows:
1. Remove steel handle, spacer, screw and washer from
plastic bag.
2. Assemble washer and spacer over screw and insert into
hole on door steel handle. Place washer on back side of
steel handle.
3. Insert screw into threaded hole on door on fire door fur-
nace front and tighten. Washer should be between weld-
ment and door.
4. Screw wood handle (packaged with draft tube) to steel
handle.
controls
Remove control from accessory box and install as follows:
1. Remove the four screws that hold the gasket to the
damper panel.
2. Mount the damper control to the draft tube using screws
removed above. Make sure gasket stays in place. (Fig. 6)
3. Loosen the two screws located at slotted end of draft
tube, and remove remaining 10 screws. Make sure gasket
stays in place.
4. Mount damper control and draft tube assembly to furnace
as shown in Fig. 6.
installation
Typical furnace installation is shown in Fig. 2 (page 6). Place
your furnace in the pre-selected location, making sure it is level.
Proceed as follows:
before installing - check:
draW collar
Attach the draw collar around the smoke pipe and tight against the
furnace cabinet so room air cannot leak into the return air cabinet.
Refer to Fig. 3 for installation. Check that a factory installed draw
collar is installed over smoke pipe and against inner panel divider.
loWer firebrick
Refer to Fig. 4 for proper installation. (Factory installed)
1. Place three large firebrick along lower rear of the firebox.
Center the end bricks.
2. Next place four large brick in lower left and lower right of
firebox.
grates
Refer to Fig. 4 for proper installation. (Factory installed)
To install the grates, start at the rear of the furnace and work
toward the front. Install grates with the wide side up as shown in
Fig. 4.
uPPer firebrick
Refer to Fig. 4 for proper installation. (Factory installed)
1 . Loosen the upper brick retainers if necessary and install
three 9 x 6 bricks along the upper rear of the firebox.
2. Install four 9 x 6 bricks along the upper right and left sides
of the firebox.
3. Tighten brick retainers to hold brick in place.
4. See Fig. 4 for completed assembly.