I
USER'S INFORMATION
MANUAL
G
lfHCllHC't'
••,..a
CUH'HlO
ama
(~
~
"'''Jl,
I.:lA;r;~'"
1509001
Certified Quality
Management System
MODELS:
33" Multi-position
Gas Furnaces
(Manufactured Housing or Modular Home Applications)
I_~~--~-~~~~~-~~-~~~~~
TABLE OF CONTENTS
SAFETY
1
Removing Filters For Manufactured (Mobile) Home
INSTRUCTIONS FOR EXAMINING THE
And Modular Home Installations Without A Return
FURNACE INSTALLATION
2
Air Duct System And Plenum
4
START-UP AND SHUTDOWN INSTRUCTIONS
2
BLOWER CARE
.4
HOW YOUR GAS FURNACE WORKS
3
MOTOR LUBRICATION
5
OPERATING INSTRUCTIONS
3
SERVICE INFORMATION
5
TO TURN OFF THE APPLIANCE
3
TROUBLESHOOTING
PROBLEMS
5
FURNACE MAINTENANCE - USER INFORMATION
4
FURNACE CONTROL DIAGNOSTICS
5
EXTERNAL AIR FILTERS
4
FURNACE MAINTENANCE - DEALERICONTACTOR
5
How to Clean your Filter
4
REPLACEMENT PARTS LIST
5
Removing Filters For Manufactured (Mobile) Home And Modular
WIRING DIAGRAM
5
Home Installations Using A Return Air Duct System And Plenum
4
LIMITED WARRANTY
6
CONTACT INFORMATION FOR USA
CONTACT INFORMATION FOR CANADA
.
Contact us by mail:
.
Manufacturer:
.
Go to website at
www.york.com
click on "contact", then click on
DISTRIBUTED BY:
Johnson
Controls
Unitary Products
"contact form" and follow the instructions.
StyleCrest
.
Contact us by mail:
801 W. 37th Street
Johnson
Controls
Unitary Products
Building
#7
Consumer
Relations
Wichita, Ks 67219
5005 York Drive
Norman, OK 73069
We recommend that the user read all sections of this
manual and keep the manual for future reference.
rAWARNINGl
FIRE OR EXPLOSION HAZARD • Failure to follow safety warnings
exactly could result in serious injury, death, or property damage.
Do not store or use gasoline
or other flammable
vapors
and
liquids
in the vicinity
of this or any other appliance.
WHAT TO DO IF YOU SMELL GAS:
Do not try to light any appliance.
Do not touch any electrical switch; do not use any phone (includ-
ing cell phone) in your building.
Leave the building immediately.
Immediately call your gas supplier from a neighbor's phone. Fol-
low the gas supplier's instructions.
If you cannot reach your gas supplier, call the fire department.
Installation
and service must be performed
by a qualified
installer, service agency or the gas supplier.
SECTION I: SAFETY
I
A
I
This is a safety alert symbol. When you see this symbol on
~_
!abels or in manuals, be alert to the potential for personal
mjury,
Understand and pay particular attention to the signal words DANGER,
WARNING, or CAUTION.
DANGER indicates an imminently
hazardous situation, which, if not
avoided, will result in death or serious
injurv.
WARNING
indicates a potentially
hazardous situation, which, if not
avoided, could result in death or serious
injurv.
CAUTION
indicates
a potentially
hazardous
situation,
which, if not
avoided may result
in minor
or moderate
injurv.
It is also used to
alert against unsafe practices and hazards involving only property dam-
age.
1.
The furnace area must be kept clear and free of combustible mate-
rials, gasoline and other flammable vapors and liquids.
2.
Insulating materials
may be combustible.
The furnace must be
kept free and clear of insulating materials. The furnace area must
be examined when installed in an attic or other insulated space or
when insulation is added to be sure that the insulation material has
been kept away from the furnace.
3.
The furnace needs air for combustion in order to operate properly
and safely. Do not block or obstruct air openings on the furnace,
air openings to the area where the furnace is installed, or spaces
around the furnace.
4.
Follow the instructions
exactly as shown on the OPERATING
INSTRUCTION
LABEL on the furnace or the "START-UP AND
SHUTDOWN INSTRUCTIONS" section of this manual when light-
ing the furnace or turning the furnace off.
5.
Should the gas supply fail to shut off or if overheating occurs, shut
off the gas valve to the furnace before shutting off the electrical
supply.
6.
Do not use this furnace if any part has been under water. A flood-
damaged furnace is extremely dangerous. Attempts to use the fur-
nace can result in fire or explosion. A qualified service agency
should be contacted to inspect the furnace and replace all gas
controls, control system parts, electrical parts that have been wet
or the furnace if deemed necessary.
420706-UUM-A-1008
