YTL YTL-002-353, Инструкция по эксплуатации и сборке

Страница: 3 / 19

- 3 -
GENERAL WARNINGS
READ and UNDERSTAND this manual completely before using the Push Sweeper.
Operator must read and understand all safety and warning information, operating instructions,
maintenance and storage instructions before operating this equipment. Failure to properly operate
and maintain the push sweeper could result in serious injury to the operator or bystanders.
Operation Warnings

Do not at any time carry passengers, sit or stand on the sweeper.

Do not allow children to play on, stand upon or climb in the sweeper.

Always inspect the sweeper before using to assure it is in good working condition.

Replace or repair damaged or worn parts immediately.

Always check and tighten hardware and assembled parts before operation.

Avoid large holes and ditches when using the sweeper.

Be careful when operating on steep grades (hill) the sweeper may tip over.

Do not push close to creeks, ditches and public highways.

Always use caution when unloading sweeper.

Never tow the sweeper with a motorized vehicle.
.
Crush and Cut Hazards

Always keep hands and feet clear from moving parts while operating the equipment.

Always clear and keep work area clean when operating.

Always wear safety gear, eye protection, gloves and work boots when operating the sweeper.
.
WARNING
The warnings, cautions, and instructions outlined in this instruction manual cannot cover all
possible conditions or situations that may occur. It must be understood by the operator that
common sense and caution are factors which cannot be built into this product and must be supplied
by the operator.
PROP 65 WARNING
This product contains chemicals known to the state of California to cause cancer, birth defects, or
other reproductive harm.
Assembly Is Required
This product requires assembly before use. See “Assembly” section for instructions. Because of the
weight and/or size of the push sweeper, it is recommended that another adult be present to assist
with the assembly.
INSPECT ALL COMPONENTS closely upon receipt to make sure no
components are missing or damaged.