19
Installing Sample Bottle(s)
There are several bottle configurations available for the ProSample P and ProSample P-12. Plastic (PE) and glass bottle
sets are available. Please see the
Replacement Parts and Accessories
section on page 60 for a complete listing of
available bottle sets.
If multiple bottles will be installed in a ProSample P or ProSample P-12, a distributor arm must be installed. Please see
A single 10 liter PE bottle can be placed in the ProSample PM and ProSample PM-12, but no other bottles can be used,
as a distributor arm cannot be installed in the mini samplers.
Remove the Top of the Housing
Disconnect the clips that hold the top part of the housing to the rest of the instrument. Lift the top part of the housing
off the instrument.
Prepare Sample Bottles and Install
Ensure the sample bottles are clean and suitable for use before installing in the bottom ProSample housing.
NOTE:
A fixing plate is included with some bottle sets. If a fixing plate is included with your bottle set, it should
also be installed in the bottom ProSample housing.
Removal of the top part of the ProSample housing
1
2
Instrument Setup and Calibration
