8
8.3 Daily Alarm Function:
Press “ MODE/SET” button to select to view:
When viewing the alarm time, hold “MODE” button for 3 seconds to enter alarm
time setting. Press “+” or “- “button to adjust the alarm time. Press “MODE”
button to confirm the setting.
Press “ALARM ON/OFF” button to switch alarm on or off. If it is on, “
”
shown on the LCD.
When alarming, alarm icon “
” flash. Press “SNOOZE” button to activate the
snooze alarm, (“
” flash on the LCD). The alarm will snooze for around 5
minutes, then it alarms again. This snooze function can be enabled for maximum
7 times.
Except “SNOOZE” button, press any buttons to stop the snooze alarm. Otherwise,
the alarm signal sounds for about 2 minutes, and then stops automatically.
9. Dimmer
Press “DIMMER” button to adjust the LED brightness.
10. Low battery indication:
The low battery icon “
”will appear and indicating that thermo sensor is in
low battery status. The batteries should be replaced.
11. Precautions
Use a pin to press the reset button if the unit does not work properly.
Avoid placing the clock near interference sources/metal frames such as computer or TV sets.
The clock loses its time information when the battery is removed.
Do not expose it to direct sunlight, heavy heat, cold, high humidity or wet areas
The outdoor sensor must not be set up and installed under water. Set it up in away direct
sunlight and Rain
Never clean the device using abrasive or corrosive materials or products. Abrasive cleaning
agents may scratch plastic parts and corrode electronic circuits
If there is any inconsistency of weather forecast between Local Weather Station and this unit,
the Local Weather Station's forecast should prevail. The manufacturer will not take
responsible for incorrect forecasting from this unit
Time Time & Day of Week Alarm Time ( “AL” shown on the LCD)
