Young 32400 SERIAL INTERFACE, Инструкция по эксплуатации, Страница: 4 / 10

Page 3
32400-90(R)
SERIAL COMMANDS TABLE
Command Description Notes:
CMD100
OPERATE Places unit in continuous or polled operation
CMD110 PAUSE Interrupts/pauses operation
CMD200 n DAMPING (0=NONE, 1=FAST, 2=SLOW) Determines compass measurement averaging (32500 Only)
CMD210 n FORMAT:
0 ASCII
1 POLLED ASCII
2 NMEA (KTS, DIR)
3 NMEA (KTS, DIR, TEMP, RH, BARO)
4 RMYT
5 PRECIP
6 PRECIP POLLED
7 ASCII 2
9 DIAGNOSTIC
Determines serial output format.
See section 3.1 for more detailed information.
PRECIP formats substitute tipping bucket precipitation counts for
the VIN4 voltage measurement.
ASCII 2 omits VIN measurement values from the output string
CMD220 n OUTPUT RATE (0=15Hz, 1=0.1Hz, 2=2Hz) The rate at which serial data strings are sent.
CMD230 c POLL CHARACTER (0-9, A-Z) Sets the unique, single alphanumeric character polling address
CMD240 nn BAUD RATE:
12 = 1200, 48 = 4800, 96 = 9600,
192 = 19200, 384 = 38400
Selects one of several preset baud rates. If you change baud rate
while connected, your external device must also be changed in
order to continue communicating with the 32400
CMD250 n INPUT TYPE (1 = PULSE/POT, 2 = VIN3/VIN4) Determines wind speed & direction inputs to use for output
calculation. Type 2 requires 0 to 5000 mV = 0 to 100 m/s (VIN1)
and 0 to 540 degrees (VIN2). Type 2 typically used for 86000 family
of 2D Ultrasonic Anemometers.
CMD260 nnnn BARO RANGE LOW (hPa) Sets barometer low range at 0.0VDC (0500 hPa default)
CMD270 nnnn BARO RANGE HIGH (hPa) Sets barometer high range at 5.0VDC (1100 hPa default)
CMD280 nnn
PROPELLER PITCH (mm/rev) Sets sensor cup wheel/propeller pitch
03002: 750 mm/rev
04101/4106/05103/05106: 294 mm/rev (default)
05108: 500 mm/rev
05305: 307 mm/rev
CMD900 REPORT PARAMETER SETTINGS Returns list of current settings in unit
CMD910 START COMPASS CALIBRATION See section 3.1 (32500 only)
CMD920 STOP COMPASS CALIBRATION See section 3.1 (32500 only)
X Alternative command to enter OPERATE mode Places unit in continuous or polled operation
3xESC Alternative command to PAUSE Interrupts/pauses operation
3xCNTL-S Alternative command to START calibration See section 3.1 (32500 only)
3xCNTL-X Alternative command to STOP calibration See section 3.1 (32500 only)