1. Loosen muffler exhaust clamp.
2. While securely supporting the stock muffler
assembly, remove the muffler mount bolt and
carefully remove the stock muffler assembly.
Note: Exhaust gasket will not be used with the
Yoshimura slip-on system.
Removal
Installation
3. Install muffler tailpipe assembly onto stock header
outlet and align muffler bracket to the frontside of
the muffler mount. Secure using
M8X40,
8mm
bolt,
M8ALCSW-01,
countersink washer, and
stock nut. Torque to factory specifications.
4. Torque
03019143,
exhaust clamp to 9.5 Nm (7 ft-
lb, 0.95 kg-m).
5. Install
RACE-SPS-1,
medium exhaust spring
between muffler and tailpipe.
6. Before starting vehicle, check for proper
clearance between new exhaust system and
rear suspension (i.e. tire, swingarm, brakes,
rear shock, and etc.) If any problem is found,
please carefully follow through the installation
steps again. If problem still persists, please call
Yoshimura Tech Department at (800) 634-9166 /
in CA (909) 628-4722.
7. It is recommended that the muffler and tailpipe
be wiped down with rubbing alcohol to remove
oil and fingerprints. This will help prevent
tarnishing of the finish after the exhaust is
heated up.
Note: After starting vehicle, it is normal for new
exhaust system and muffler to emit
smoke until oil residue burns off.
3
CAUTION: Exhaust system can be extremely hot.
Let motorcycle cool down before
beginning installation. Always wear
hand and eye protection and take
precautionary measures to avoid
injury.
WARNING: Always properly support vehicle with
a stand and/or lift when servicing or
performing any work. Unstable
vehicles may present dangerous
conditions and may cause property
damage and/or personal injury.
NOTE: Read through all instructions before
beginning installation.
1. Install
14720-435D,
tailpipe outlet into muffler
inlet.
2. Install
03019143,
exhaust clamp onto tailpipe
inlet.
