4. For remote control wiring connection to the fan:
4-1. Follow the diagram below and be sure that exposed wires are secured inside wire nuts or the
terminal block.
4-2. When the wiring is completed, gently push wires into the junction box with wire nuts pointing upward.
Note: Wires from the house may vary in color and may not include ground wire (green).
From House
From Fan
( from downrod )
( from mounting bracket )
From Remote
( for ground wire )
( for light kit )
(AC-N)
(AC-L)
Black
White
Blue
Black
White
( Motor - N )
( Motor - L )
Secure with twist - lock wire nuts (Included).
White
White
Black
Black
Blue
Green
Green
Green
Orange
( for up light kit )
Orange
1.
Push up the Canopy until the two screws on mounting bracket
are engaged with Key Holes in canopy.
2.
Rotate the canopy slightly until the two screw heads are in the
small end of the Key Holes.
3.
Tighten both screws.
Canopy
Key Holes
Screw
III. Install the canopy
Receiver
Code Switches
Transmitter
Code Switches
1
2
3
4
1
2
3
4
II - Remote Control
1.Prepare the parts of the remote control.
2. Setting the code on the transmitter.
2-1. Remove the battery cover of the remote control.
2-2. Slide code switches to your choice for an ON and OFF position. Use a small screwdriver to slide each
of the switches.
2-3. Install a 9V DC battery ( included).
2-4. Install battery covers on transmitter.
3. Setting the code on the receiver:
3-1. Slide the code switches to the receiver. Be sure that the code is similar to the code set at the
transmitter.
P4