Printed in China
w w w . y o r k v i l l e . c o m
Quality and Innovation Since 1963
Yorkville Sound
550 Granite Court
Pickering, Ontario
L1W-3Y8 CANADA
Yorkville Sound Inc.
4625 Witmer Industrial Estate
Niagara Falls, New York
14305 USA
Yorkville C120P Loudspeaker
SPEAKER
Powered
*This Product is Warranted against
manufacturing defects for a period of one year
hank you for choosing Yorkville's Coliseum C120P powered
monitors for your sound reproduction needs. We hope you will
take the time to read this brief manual and if you have any
questions we can be reached on-line at [email protected].
Front LEDs
Blue LED - indicates power ON.
Orange LED - indicates "clip/limit." The built-in non-defeat-
able LIMITER helps to prevent distortion. It operates con-
tinuously and has minimal effect on sound quality, howev-
er its operation does indicate that the C120P is at maxi-
mum volume and may be on the verge of distortion if
the Orange LED is on more of the time than simply
flashing on peaks.
Controls and Connections
(from the top)
GAIN Control - turn this control clockwise to
increase the volume, or counterclockwise to
reduce volume. If the orange "clip/limit" LED on
the front of the enclosure illuminates, reducing
the GAIN setting will decrease its activity.
BASS Control - adjust this control clockwise
or counter-clockwise to increase or decrease
the emphasis in the low frequency region. A
center setting is neutral.
Tip: if the orange "clip/limit" LED is illuminating
overtly at comparatively low sound levels, it
may be a result of the BASS being turned up
too far. Reducing the BASS setting will help to
compensate. This also applies to the TREBLE
control.
TREBLE Control - adjust this control clockwise or
counter-clockwise to increase or decrease high fre-
quency emphasis. A center setting is neutral. (See
BASS control.)
¼-Inch BALANCED LINE Input - this is for monophon-
ic, Tip-Ring-Sleeve (balanced), line-level signals and is
not internally connected to the STEREO LINK OUTPUT.
Its main purpose is to provide the mixing technician with
the ability to isolate mixer outputs, or patches, through a
dedicated monitor.
Balancing code is; Tip= (+) 0° phase, Ring= (-)
180° phase, and Sleeve=Ground.
Tip: if you want to add-on a second C120P, con-
nect your signal source via the 1/8-inch CD
STEREO LINE IN jack, not the ¼-inch BALANCED
LINE input. Now you can interconnect the second
C120P as stated below.)
1/8-inch STEREO LINK OUTPUT Jack - use a 1/8-inch
stereo cable here to connect an additional C120P. Make
sure the STEREO/MONO button is in the STEREO posi-
tion (up) otherwise the additional speaker will not work.
MONO/STEREO Pushbutton - regulates the signal com-
ing in through the 1/8-inch CD/STEREO LINE IN jack.
Use the STEREO setting when the audio signal is stereo
and/or interconnecting an additional C120P. Use the
MONO setting when no other C120P is linked and you
want Left and Right blended.
Tip: if you are adding another C120P via the
STEREO LINK OUTPUT jack, be sure the
MONO/STEREO pushbutton is in the STEREO
position so that the additional speaker will work
1/8-inch CD/STEREO LINE IN Jack - this is
where you connect your stereo
tuner/amplifier, CD player or tape deck.
When used in the recording studio, you
may run a mono line from the mixer to
this input rather than the ¼-inch BAL-
ANCED LINE IN jack.
Additional
Your C120P can be painted. We suggest
that you remove the front grill and mask
off the speakers and rear connector panel to
avoid getting paint on them. If you want to paint
the C120P without removing the grill, a small amount of
overspray will not hurt the components. However, too much
paint will destroy your speakers permanently.
MADE
IN CH
INA
FABR
IQUÉ E
N CHIN
E
YORK
VILLE
SOUN
D
TORO
NTO, C
ANAD
A
BALA
NCE
D
LINE
IN
CD/S
TER
EO
LINE
IN
(from LINK of
SOURCE C120P)
SEC
OND
C120
P
FOR
MIN
I-JAC
KS (1
/8-in
ch)
WHE
N LIN
KING
USE
ONL
Y ST
ERE
O CA
BLES
C120
P
CD/S
TER
EO
LINE
IN
LINK
OUT
8 0
W a
t t s
C120P
Yorkville
230V
50Hz
0.15A
120V
AC
60Hz
0.3A
TYPE: YS1025
1v2
WARNING SHOCK HAZARD DO NOT OPEN
AVIS RISQUE D
E CHOC ELECTRIQUE NE PAS OUVRIR
RISK OF
ELECTR
IC SHOC
K
DO NOT
OPEN
NOT SU
ITABLE FOR IN-WALL MOUNTING
WARN
ING: TH
E BON
DING C
ONDUCT
OR IN T
HIS SU
PPLY C
ORD
IS PRO
VIDED FO
R PERFORM
ANCE
REASONS
ONLY
LE COND
UCTEUR
DE TER
RE DE P
ROTECT
ION DAN
S CE C
ORDON
D'ALIM
ENTATIO
N EST S
EULEME
NT POUR
RAISON
S DE PE
RFORM
ANCE
AVIS RIS
QUE DE C
HOC
ELECTRIQ
UE NE P
AS OUVR
IR
Level
Treble
Bass
Balanced Line In
Link Out
Mono
CD/Stereo Line In
Stereo
Frequency response: 65Hz to 19KHz +/-3dB
Power: 80 Watts burst avg. power
Max SPL: 101dB @ 1 meter
Connectors: 1/4-inch Phone and 1/8-inch Mini Jack
Dimensions: W 17.8 x D 6.5 x H 10.25 inches
W 17.8cm x D 16.5cm x H 26cm
Weight: 8.8 lbs (4.0 kg.)
T
DOC-c120-spec-1v4.pdf
