York YFFE18BXEXBH-RX, Инструкция по установке и эксплуатации

Страница: 10 / 36

10
Installation Place
(1) Install the indoor unit level on a strong wall, floor, ceiling which is not subject to vibration.
(2) The inlet and outlet ports should not be obstructed.The air should be able to blow all over the room.
(3) Install the unit near an electric outlet or special branch circuit.
(4) Do not install the unit where it will be exposed to direct sunlight.
(5) Install the unit where connection to the outdoor unit is easy.
(6) Install the unit where the drain pipe can be easily installed.
(7) Take servicing etc. into consideration and leave the spaces shown in the figure below. Also install the
unit where the filter can be removed.
(1) Place where air circulates.
(2) Place free from heat radiation from other heat sources.
(3) Place where drain water may be discharged.
(4) Place where noise and hot air may not disturb the neighborhood.
(5) Place where there is not heavy snowfall in the winter time.
(6) Place where obstacles do not exist near the air inlet and air outlet .
(7) Place where the air outlet may not be exposed to a strong wind.
(8) Place surrounded at four sides are not suitable for installation. A 1m or more of overhead space is
needed for the unit.
(9) Mount guide-louvers to place where short-circuit is a possibility.
(10) When installing several units, secure sufficient suction space to avoid short circuiting.
Under ceiling Floor console
2 cm
or more
Ceiling
Indoor unit
30 cm
or more
Left Right
1.5m
30 cm
or more
30 cm
or more
1.5m
1.5m
Left
Right
may be difference
Decide the mounting position with the customer as follows.
Select the place of installation satisfying the following conditions and, at the same time, obtain a consent
from the client or user.