York MILLENNIUM, Руководство по эксплуатации

Страница: 9 / 16

9
YORK INTERNATIONAL
FORM 150.62-NM3
OPTIONAL PRINTER INSTALLATION
The optional printer combined with the RCC option
allows the operator to obtain a remote printout through
the RCC device. The printer to RCC distance should
be limited to 25 ft.
YORK recommends the field tested WEIGH-TRONIX
model 1220 printer (or former IMP 24). This is a com-
pact low cost printer that is ideal for service work and
data logging.
The WEIGH-TRONIX printer can be obtained by con-
tacting WEIGH-TRONIX for purchase information at:
WEIGH-TRONIX
2320 Airport Blvd.
Santa Rosa, CA 95402
Phone: 1-800-982-6622 or 1-707-527-5555
(International Orders Only)
The part number for the printer that is packaged spe-
cifically for YORK is P/N 950915576. The cable to
connect the printer can either be locally assembled from
FIG. 1 – PRINTER TO MICROBOARD ELECTRICAL CONNECTIONS
LD02722
the parts listed, or ordered directly from WEIGH-
TRONIX under part number 287-040018.
PARTS
The following parts are required:
1. WEIGH - TRONIX model 1220 printer.
2. 2.25" (5.7cm) wide desk top calculator paper.
3. 25 ft. (7.62m) maximum length of Twisted
Pair Shielded Cable (minimum 3 conductor), #18
AWG stranded, 300V minimum insulation.
4. One 25 pin Cannon connector and shell.
Connector: Cannon P/N DB-25P or equivalent.
Shell: Cannon P/N DB-C2-J9.
Assembly and Wiring
All components should be assembled and wired as
shown in Figure 1. Strip the outside insulation back
several inches and individual wires about 3/8" (9.5 mm)
to connect the cable at the Microboard. Do not connect
the shield at the printer-end of the cable.
3