York MILLENNIUM YCUL0045SC, Установка, эксплуатация и обслуживание

Страница: 126 / 172

YORK INTERNATIONAL
126
PUMPDOWN (LLSV) CONTROL
Each system has a Pumpdown feature upon shut-off.
On a non-safety, non-unit switch shutdown, all compres-
sors but one in the system will be shut off. The LLSV will
also be turned off. The final compressor will be allowed
to run until the suction pressure falls below the cutout or
for 180 seconds, which ever comes first. Manual
pumpdown from the keypad is not possible.
LOAD LIMITING
Load Limiting is a feature that prevents the unit from
loading beyond the desired value. 2 and 4 compressor
units can be load limited to 50%. This would allow only 1
compressor per system to run. 3 and 6 compressor units
can be load limited to 33% or 66%. The 66% limit would
allow up to 2 compressors per system to run, and the
33% limit would allow only 1 compressor per system to
run. No other values of limiting are available.
There are two ways to load limit the unit. The first is
through remote communication via the ISN. Refer to the
section on ISN control for more information.
A second way to load limit the unit is through closing
contacts connected to the Load Limit (CTB1-Terminals
13-21) and PWM inputs (CTB1-Terminals 13-20). Stage
1 of load limiting involves closing the Load Limit input.
Stage 2 of load limiting involves closing both the Load
Limit and PWM inputs. The first stage of limiting is ei-
ther 66% or 50%, depending on the number of compres-
sors on the unit. The second stage of limiting is 33%
and is only available on 3 and 6 compressor units. Table
25 shows the load limiting permitted for the various num-
ber of compressors.
COMPRESSOR RUN STATUS
Compressor run status is indicated by closure of con-
tacts at CTB2 – terminals 25 to 26 for system 1 and
CTB2 – terminals 27 to 28 for system 2. The respective
contact will close anytime a compressor is running in
that particular system.
The compressor Run Status contacts can also be used
to cycle the evaporator fan contactor with the compres-
sors.
ALARM STATUS
System or unit shutdown is indicated by normally-open
contacts opening whenever the unit shuts down on a
unit fault, or locks out on a system fault. System 1 alarm
contacts are located at CTB2 - terminals 29 to 30. Sys-
tem 2 alarm contacts are located at CTB2 - terminals 31
to 32. The alarm contacts will close when conditions
allow the unit to operate.
COMPRESSOR SEQUENCING
The unit control will attempt to equalize the total run
hours on individual compressors within a system. When
a system is about to start, the compressor with the least
run time in that system will be the first to start. When
the system has to load, the next compressor to start
will be the one with the least run time that is currently
not running in that system.
TABLE 25 – COMPRESSOR OPERATION – LOAD LIMITING
COMPRESSORS IN UNIT STAGE 1 STAGE 2
2 50% –
3 66% 33%
4 50% –
6 66% 33%
Unit Controls