PART NAMES
INDOOR UNIT
3
Air inlet
2
1
■
INDOOR UNIT
1
Front panel frame
8
Infrared signal receiver
2
Front panel
9
Remote controller
3
Air filter
0
Drain hose, refrigerant con-
4
Horizontal air flow grille
necting pipe
5
Vertical air flow louver
-
Connective cable
6
Room temperature sensor
=
Stop value
7
Display panel
-
Active Carbon
Electrostatic Fiber Filter (Standard)
4
5
6
7
8
Air outlet
OUTDOOR UNIT
9
10
Air inlet
■
DISPLAY PANEL
OPERATION Indicator:
The indicator flashes once every
second
after power is on and illuminates when the air
connditioner is in operation.
TIMER Indicator:
The indicator illuminates when TIMER is
set ON.
PRE-DEF. Indicator
(For cooling & heating model only): The
air conditioner starts defrosting automatically if outdoor unit
frosts in heating operating. At this time, PRE.-DEF. Indicator
illuminates.
AUTO Indicator:
This indicator flashes when the air
conditioner
is in AUTO operation.
11
ECON Indicator:
This indicator illuminates while the air
conditioner is
in economic operation.
12
Air outlet
DISPLAY PANEL
NOTE
The display panel on the indoor unit would look like
one of following:
NOTE
All the pictures in this manual are for explanation purpose
only. They may be slightly different from the air conditioner
you purchased. The actual shape shall prevail.
OPERATING TEMPERATURE
Infrared signal receptor
Mode
Cooling
Heating
Drying
Model 07-21
TIMER OPERATION
Temperature
operation
operation
operation
PRE-DEF
Room temperature
17°C-32°C
0°C-30°C
17°C-32°C
18°C-43°C
Outdoor
(-5°C 43°C:For the
-7°C-24°C
11°C-43°C
temperature
models with low
temperature
Infrared signal receptor
cooling system)
OPERATION AUTO
TIMER
ECON
PRE-DEF
Model 24-36
Cooling/Heating
OPERATION
AUTO
TIMER
PRE-DEF.
Cooling Only
OPERATION
AUTO
TIMER
CAUTIONS
1.
If air conditioner is used outside of the above conditions,
certain safety protection features may come into operation
cause the unit to function abnormally.
2.
Room relative humidity less than 80%. If the air
conditioner operates in excess of this figure, the surface of
the air conditioner may attract condensation. Please sets
the vertical air flow louver to its maximum angle (Vertically
to the floor), and set HIGH fan mode.
3.
Optimum performance will be achieved within these
operating temperature.
4
ENGLISH
J174_lastRev4.pmd
4
3/14/05, 3:27 PM
