York DWCPXY, Руководство пользователя

Страница: 17 / 24

Wired Zone Controller XK41 & XK47
1
1
Fig.3.9.1 E-heater Setting
3.10 Blow Setting
Blow function: After the unit is turned off, this function assists in water evaporation to avoid mildew
in the indoor unit.
In the Cooling or Dry mode, press
“Function”
until the unit enters the Blow setting status. Then
press
“Enter/Cancel” to activate this function.
When the Blow function is activated, press
“Function”
repeatedly until reaching the Blow setting
status. Then press
“Enter/Cancel” to cancel this function.
The Blow function setting is shown in Fig.3.10.1 below.
Press Function repeatedly until
reaching the E-heater setting status.
Press Function repeatedly until
reaching the E-heater setting status
again.