1. For channel to work correctly when remote is set to automatic mode, it has to be activated. If automatic mode is
chosen for the channel and the channel number is flashing, that means device does not work in this mode.
2. Difference between automatic time of roller shutter opening and closing cannot be shorter than 32 minutes. In case of
smaller than minimal time difference fault message will appear and none of the changes will be saved.
3. Pressing UP or DOWN button in automatic mode will show currently set opening / closing time and symbol of current
process.
4. Estimated battery lifespan is one year if the device runs 4 commends a day in average.
5. Batteries should be changed when LED diode stops flashing when channel is being changed or receiving device stops
reacting to commands.
6. When placing the battery ensure that polarity is correct.
7. When on display all channels are selected remote controls all programmed devices on all channels at the same time.
No programming functions can be performed on group channel. All devices programmed to any other channel can be
controlled on group channel without additional programming.
8. For all devices, that are programmed on all the channels, to work at programmed time, group channel and automatic
mode should be chosen.
Batteries contain substances that may be hazardous to health and may pollute the environment. Used batteries should
be disposed of properly.
CAMELEO_1RwT | CAMELEO_5RwT
In order to fully explore available functions of CAMELEO series please take a moment and read this manual before using the device.
CAMELEO transmitters are compatible with all YOODA brand devices.
Detailed description
Changing work mode
www.sukcesgroup.pl
1. Manual work mode: standard mode without using time programming function.
2. Automatic mode: standard mode with activated automatic work time.
3. Random work mode: automatic mode with random time of work (15 minutes difference from programmed time).
4. Work mode changes for all channels.
5. Automatic work mode has three different options. Active option is indicated by the number on the display.
'0' - manual mode.
‘1’ – automatic or random mode,
allows to program time of automatic work for each day individually.
‘2’ – automatic or random mode,
allows to program single time of automatic work for every day of the week (Mon-Sun).
‘3’ – automatic or random mode,
allows to program three different times of automatic work – Mon-Fri, Sat, Sun.
By pressing
P2 programming button
for about 3 seconds work mode
will change to manual mode.
By pressing
P2 programming button
for about 3 seconds work mode
will change to first
of automatic mode.
By pressing
P2 programming button
for about 3 seconds work mode
will change to second
of automatic mode.
By pressing
P2 programming button
for about 3 seconds work mode
will change to third
of automatic mode.
By pressing
P2 programming button
for about 3 seconds work mode
will change to first
random mode.
By pressing
P2 programming button
for about 3 seconds work mode
will change to second
random mode.
By pressing
P2 programming button
for about 3 seconds work mode
will change to third
random mode.
Pressing
P2 programming button
will cause for work mode
to change again.
