ARTISTIC_1RT | ARTISTIC_5RT | ARTISTIC_15RT
In order to fully explore available functions of ARTISTIC series please take a moment and read this manual before using the device.
ARTISTIC transmitters are compatible with all YOODA brand devices.
Changing automatic opening time
Changing automatic closing time
www.sukcesgroup.pl
1. Time can be set only when device is in automatic working mode.
2. Longer than 10 seconds pause between series of button clicks during programming will cause device to switch off
from programming mode without saving any changes.
1. Time can be set only when device is in automatic working mode.
2. Longer than 10 seconds pause between series of button clicks during programming will cause device to switch off
from programming mode without saving any changes.
Using UP and DOWN
buttons set
current time.
Press and hold
TIME SET button
for about 5 seconds.
Press
TIME SET button
to switch between
setting hour or minutes
of current time.
To save settings
press and hold
TIME SET button
for about 5 seconds
(elements on display will
stop flashing).
Automatic opening time
flashes on the screen.
Automatic opening
time flashes
was successfully changed.
Display shows current time.
KONIEC
ZMIANY
Press
WORK MODE button
once to switch to
closing time setup.
Press and hold
TIME SET button
for about 5 seconds.
Using UP and DOWN
buttons set
current time.
Press
TIME SET button
to switch between
setting hour or minutes
of current time.
To save settings
press and hold
TIME SET button
for about 5 seconds
(elements on display
will stop flashing).
Automatic closing
time flashes
was successfully changed.
Display shows current time.
KONIEC
ZMIANY
Automatic opening time
flashes on the screen.
Automatic closing time
flashes on the screen.
Programming first transmitter to R-type motors
1. Way of programming first transmitter depends on type of radio receiver. When programming first transmitter please
follow instruction of the device that is going to be controlled by the transmitter.
2. Longer than 5 seconds pause between series of button clicks during programming will cause device to switch off from
programming mode without saving any changes.
3. Programming first transmitter will result in deleting all previously programmed transmitter.
Turn on
power supply
or press microswitch
(for 2 sec.) when power is on.
Motor will make a sound.
Roller shutter will make
an up/down move.
Motor will
make a sound.
Press
programming button
(P2) on the remote.
or
Roller shutter
will make
an up/down move
and the motor will
make a few short
sounds.
Motor will
make a sound.
Press
programming button
(P2) on the remote.
Press
UP button
on the remote.
