19
COMMENTS/QUESTIONS? EMAIL [email protected]
LCD DISPLAY/CONTROLLER PROGRAMMING AND USE:
Your waterproof 3” LCD display allows you to
monitor and control your pedal-assist bike (Figure 1).
BASIC OPERATION
Power on and off by holding down the Power on
and off by holding down the power button located
on the control band near the left hand grip along
with the controls to increase (+) or decrease (-)
the Power Assist (PAS) level (Figure 2). The LCD
display screen is centered on the handlebars. The
PAS level is indicated on the screen, middle left.
There are 6 manual levels you may select at any
time during powered operation, by pressing the
+ or - button. Zero (0) is natural pedaling with no
assist from the motor. Four lateral bars located
above the power assist level display your Battery
Life indicator.
Located next to the control band on the left side
of the handle bar is the throttle lever (Figure 3).
With the power on, your bike will move by either
pedaling (with or without motor assistance based
on assist level programmed) or by depressing
the throttle lever. When riding at any PAS level 1
through 5, when your left thumb presses down on
the throttle lever (Figure 3) the throttle will engage
the motor and propel the bike automatically until
the throttle is released.
To turn on and off the headlight, simply press the
“+” button and hold the “+” button down until the
light comes on (approx. 3 seconds).
Figure 1
Figure 2
Figure 3
