The
are very difficult to relocate a er being affixed to the moun ng
controller and sensor
surface. Test your
loca on before affixing the two devices to the surface.
controller and sensor
Use masking or painters tape to secure the
to the surface. Once you have
controller and sensor
the
temporarily mounted, test it out. With the app in hand, open or close
controller and sensor
the door using app and observing the status of the sensor as shown on the app (Opened or
Closed). Op onally, you may set up your automa on (e.g. turn on a light when the door is
opened) to func onally test the status change of the door - proceed to the following steps for
informa on on crea ng automa ons, then return to this step
Test the Controller and Sensor Loca on Before Installa on
Garage Door Sensor 2 should be mounted on the top panel of garage door and keep the SET
bu on at the top and the longer side parallel to the floor, otherwise the status of sensor shown
on the app (Opened or Closed) may be inaccurate
Installa on
Garage Door Controller and Sensor 2 are designed and intended for indoor use only!
8
Avoid allowing the controller and sensor to be exposed to strong impacts or vibra on
Please add the Garage Door Controller and Sensor 2 to the YoLink app before installa on
