YOKOYAMA KP6210, Инструкция по эксплуатации

Страница: 38 / 40

PF – Start the machine when presser foot is lifted up.
《
lower down the presser foot
》
ƆC – Bobbin winder is ON.
《
push the bobbin winder reel to left hand side, see pic.4 on page 6
》
bL – Buttonhole sewing lever is in wrong position.
《
put the buttonhole sewing lever to RIGHT position, see pic.6 on page 32
》
black button
36
DARNING SEWING
bracket of presser foot
1
2
1 2 3 4
darning foot
HINTS!!
MACHINE WILL BEEP A WARNING TONE AND FOLLOWING ERROR CODE W ILL APPEAR ON DISPLAY SCREEN.
THICK FABRIC SEWING
1. Lower down the needle to the position of sewing, push the black
button on presser foot.
2. P resser foot holder will lower down automatically.
3. Release the black button.
INSTAL DARNING FOOT
1. Remove the bracket of presser foot.
2. Install the darning foot, put the screw into the hole on bracket and tighten the
screw.
(Attention) To install darning foot, the pin on darning foot must be higher than the
screw on needle clamp.
SEWING OF DARNING
1. Pull the upper thread and lower thread outward. Then, low down the darning foot.
2. Fix the both ends of fabric by ball-head pin.
3. After first stitch, machine will be stop automatically. Then, pull the fabrice
outward as long as you desired.
4. Repeat step 2 & 3, When sewing is completed, pull the thread and fabrice
outward and cut the threads.
serew for bracket
serew for bracket
serew for
needle clamp
ball-head pin
pin
ball-head pin
(optional part)
fabric
Fc – Foot controller is connected to the machine.
《
Please use the foot controller to start the machine.
》
Lo – The safety device has been activated.The motor locked up because the thread is tangled.
《
Please remove the tangled thread, and then restart the machine.
》