YOKOYAMA KP6210, Инструкция по эксплуатации

Страница: 34 / 40

32
USING BUTTONHOLE FOOT
R
1 2
SEWING A BUTTONHOLE
The size of the buttonhole is automatically set by placing a button in the
automatic buttonhole foot(R).
The button holder of the foot takes a button size up to 2.5 cm (1") in diameter.
Make a test buttonhole on a sample duplicating the fabric interfacing and seams
of the actual garment.
Place the button on the fabric sample and mark the top and bottom to determine
the position of buttonhole.
Use interfacing on stretch fabrics.
1
Turn the handwheel toward you to raise the needle to its highest position.
Raise the presser foot lifter.
2 Attach the automatic buttonhole foot.(Refer to "Changing presser foot" on
page 13.)
NOTE: There should be no gap between the slider and spring holder of the
foot as shown.
6
be no gap
holder
Slider
There should
Spring
5
Starting point
3
Pull the button holder to the back, and place the button in it. Push back
the button holder toward you as far as it will go.
6
5
I
nsert the garment under the foot, and lower the needle at the starting
point. Then lower the automatic buttonhole foot.
7 8
7
Cut both needle and bobbin threads leaving about 10 cm (4") thread
ends.
Draw the needle thread to wrong side of fabric by pulling the bobbin
thread. Then, knot the threads.
8
Insert a pin inside the bartack.
Then cut the opening with a seam ripper.
Take care not to cut the stitches.
3
(B) (B) (B)
( X )
(B)
(A)
Buttonhole lever
4
Select one of buttonhole patterns.
Buttonhole foot
(A) (A)
(A)
( O )
( X )
Mark
Fabric marking
Mark
While holding the top thread, start the machine.
PROCEDURE
Pull the buttonhole lever down to the lowest point, and set it at the
left side of point A.
4
When you lay down the presser foot lever with your right hand, hold the
buttonhole foot with your left hand and push it forward gently, to ensure
there is no gap between slider and spring holder.