YOKOGAWA YFGW410, Руководство пользователя

Страница: 65 / 67

<9. Connection Device Type>
9-18
IM 01W03D02-01EN
F0906.ai
AI algorithm
PV AI Publish
Scale
O/S
Auto
Simulate
Mode.Target
Switch
Simulate Value
Operator
Input
Modbus
Device
Range
Scale
PV
PV
Mode and PV.Status
handling
Transducer
Value
Figure 9.2 Example schema of analog input object
Table 9.5 Diagnostic Status Detail
Bit Diagnostic Status Detail Description
Diagnostic
status
assignment bit
NAMUR
NE107
Category *
Diagnostic Status Detail.1
31 ADAPTER FAIL FN310 failure Bit27 F
30 ANTENNA FAIL FN110 failure Bit27 F
28 INTERNAL BUS FAIL Communication failure between FN110 and
FN310
Bit27 F
27 SENSOR FAIL Disconnection or communication error,
between the Modbus device and FN310
Bit26 F
15 DEVICE CONNECTION ERR Connection error between the Modbus
device and FN310
Bit25 C
9 LOWBAT_ALM Low remaining battery voltage Bit19 M
8 CRITICAL LOWBAT Low remaining battery voltage Bit20 M
7 ADAPTER TEMP HI FN310 temperature is above +85°C Bit22 O
6 ADAPTER TEMP LO FN310 temperature is below -40°C Bit22 O
5 ANTENNA TEMP HI FN110 temperature is above +85°C Bit22 O
4 ANTENNA TEMP LO FN310 temperature is below -40°C Bit22 O
Diagnostic Status Detail.2
31 AI1 OUT OF SERVICE AI1 O/S Mode Bit24 C
30 AI2 OUT OF SERVICE AI2 O/S Mode Bit24 C
29 AI3 OUT OF SERVICE AI3 O/S Mode Bit24 C
28 AI4 OUT OF SERVICE AI4 O/S Mode Bit24 C
15 AI1 SIMULATION ACTIVE AI1 Simulate Mode Bit17 C
14 AI2 SIMULATION ACTIVE AI2 Simulate Mode Bit17 C
13 AI3 SIMULATION ACTIVE AI3 Simulate Mode Bit17 C
12 AI4 SIMULATION ACTIVE AI4 Simulate Mode Bit17 C
Diagnostic Status Detail.3
31 DEVICE IMPEDANCE1 TOO HIGH Input1 impedance value of SENCOM is high Bit5 M
30 DEVICE IMPEDANCE1 TOO LOW Input1 impedance value of SENCOM is low Bit5 M
29 DEVICE IMPEDANCE2 TOO HIGH Input2 impedance value of SENCOM is high Bit5 M
28 DEVICE IMPEDANCE2 TOO LOW Input2 impedance value of SENCOM is low Bit5 M
*: NAMUR NE 107 “Self-Monitoring and Diagnosis of Field Devices”