2
IM 701924-01E
Component Names
Probe head
Cable
Probe interface
Add various
attachments, connect to
circuit under test
To digital oscilloscope input
Latch release lever
Output terminal
Cable
Probe head
Interface
spring pin
Variable resistor for adjusting offset voltage
Probe interface
Connects to a digital oscilloscope input.
Interface spring pins
When the probe output terminal is connected, these pins touch the pad on the
oscilloscope interface board. The probe’s power is supplied through these interface
pins. The interface pins are also used to supply a offset voltage and used by the
DL9000 to automatically detect the probe.
Cable
Connects the probe interface and the probe head.
Probe head
Connect various attachments to the signal input terminals, and then connect to the
item you want to measure.
Latch release lever
Releases the lock connecting the probe output terminal to the oscilloscope input.
Output terminal
The output terminal is a BNC connector. It connects to an oscilloscope input BNC
connector.
Variable resistor for adjusting offset voltage
You can adjust the offset voltage using an appropriate driver as described below.
Adjustment driver
Use an adjustment driver that fits into the adjustment groove. Using a driver with
a large grip or a driver with a small head can damage the adjustment turn stop or
groove.
Recommended adjustment driver bit dimensions
Head thickness (W): 0.2 to 0.35 mm; head width (L): 1.3 to 1.5 mm;
head shape: flat or Philips
L
W
