<2. Handling Cautions>
2-1
IM 01C27C01-01EN
2. Handling Cautions
This chapter provides important information on how
to handle the transmitter. Read this carefully before
using the transmitter.
EJX Series transmitters are thoroughly tested at the
factory before shipment. When taking delivery of an
instrument, visually check them to make sure that
no damage occurred during shipment.
Also check that all transmitter mounting hardware
shown in figure 2.1 is included. If the transmitter
is ordered without the process connector, the
transmitter mounting hardware will not be included.
After checking the transmitter, carefully repack it in
its box and keep it there until you are ready to install
it.
Process connector
Process connector gasket
Bolt
F0201.ai
No antenna is
provided for
Amplifier
housing code 9.
Antenna
Figure 2.1
Transmitter Mounting Hardware
2.1 Model and Specifications
Check
The model name and specifications are written on
the name plate attached to the case.
: Refer to USER'S MANUAL.
Made in Japan
TOKYO 180-8750 JAPAN
MODEL
SUFFIX
SUPPLY
OUTPUT
MWP
mA DC
V DC
STYLE
CAL
RNG
NO.
F0202.ai
Figure 2.2
Name Plate
• QR Code
The product has a QR Code pasted for efficient
plant maintenance work and asset information
management.
It enables confirming the specifications of
purchased products and user’s manuals.
For more details, please refer to the following
URL.
https://www.yokogawa.com/qr-code
QR Code is a registered trademark of DENSO
WAVE INCORPORATED.
2.2 Unpacking
Keep the transmitter in its original packaging to
prevent it from being damaged during shipment.
Do not unpack the transmitter until it reaches the
installation site.
