IM 01E20D01-01E
2-1
2. HANDLING PRECAUTIONS
2.
HANDLING PRECAUTIONS
This instrument has been inspected carefully at the
factory before shipment. When the instrument is
delivered, visually check that no damage has occurred
during transportation and check that mounting parts are
attached.
Read this section carefully as it contains important
information on handling this instrument. Refer to the
relevant sections for information not contained in this
section. If you have any problems or questions, please
contact Yokogawa sales office.
2.1 Checking Model and
Specifications
The model code and specifications are found on the
name plate located on the outside of the case. Check
that the model code and specifications match what you
have ordered.
Be sure you have your model number and serial
number available when contacting Yokogawa.
F0201.EPS
0038
*1)
Figure 2.1.1 Name Plate (Integral Flowmeter Type)
*1) In case of the sizes of 2.5 to 25 mm (0.1 to 1.0 in.) ,
“0038” is not described because it is outside the
scope of CE Marking for PED.
F0202.EPS
0038
*1)
Figure 2.1.2 Name Plate (Remote Flowtube Type)
*1) In case of the sizes of 2.5 to 25 mm (0.1 to 1.0 in.) ,
“0038” is not described because it is outside the
scope of CE Marking for PED.
2.2 Accessories
Check that the parts shown below are included in the
package:
• Centering device (wafer type only): 1 pc.
• Hexagonal wrench: 2 pcs. (one each of 1.5 mm and 3
mm nominal sizes)
