YMGI WMMS-09EW-V2B(59)4, Инструкция по установке и Руководство пользователя

Страница: 38 / 48

YMGI, Engineered Comfort Products for A Sustainable and Efficient Green World!
38
Operation Guide
1.
After installation is complete, press "ON/OFF" button on remote controller to turn on the air conditioner.
2.
Press "MODE" button to select your required mode: AUTO, COOL, DRY, FAN, HEAT.
3.
Press " " or " "
button to set your required temperature. (Temperature can’t be adjusted under auto mode).
4.
Press "FAN" button to set your required fan speed: auto, low, medium and high speed.
5.
Press "SWING" button to select fan blowing angle
NOTICE
CHANGING BATTERIES AND NOTICES
1) Press slightly along the arrowhead direction to push the back cover open on the remote control.
2) Take out the old batteries. (As show in figure)
3) Insert two new AAA1.5V dry batteries, and pay attention to the polarity. (As show in figure)
4) Attach the back cover of wireless remote control. (As show in figure)
NOTE:

During operation, point the remote control signal sender at the receiving window on indoor unit.

The distance between signal sender and receiving window should be no more than 8m, and there should be no
obstacles between them.

Signal may be interfered easily in the room where there is fluorescent lamp or wireless telephone; remote
controller should be close to indoor unit during operation.

Replace new batteries of the same model when replacement is required.

When you don’t use remote controller for a long time, please take out the batteries.

If the display on remote controller is fuzzy or there’s no display, please replace batteries.
NOTE:
When changing the batteries, do not use the old or different batteries, otherwise, it can cause the remote control to
malfunction. The operation should be in its receiving range. It should be placed 36 inches away from a TV set or
stereo. If the wireless remote control cannot operate normally, please take the batteries out, wait 30 seconds and
reinsert them. If the remote still
doesn’t operate normally, please change the batteries. If the wireless remote
control will not be used for an extended period, it is recommended to remove the batteries. Leaving the batteries in
could cause them to leak. This will cause damage to the remote control.