YMGI WMMS-09EW-V2B(59)4, Инструкция по установке и Руководство пользователя

Страница: 25 / 48

YMGI, Engineered Comfort Products for A Sustainable and Efficient Green World!
25
MOUNTING BRACKET CLEARENCE
Note: Actual mounting bracket may appear different than what is picture in the above illustration.
Install Mounting Plate and Drill Hole for Combination of Copper Line/Wire Cable/Drain Hose
NOTES:
Anchors must be put into the holes, where the solid
arrows are pointing, as shown, to secure the mounting plate
firmly and to hold the weight of the indoor unit. If more
screws/anchors are required, make sure, to keep the two
holes close to each other, at least 2 inches apart.
The mounting plate should be attached to the structural
part of the wall. Minimum clearance, as shown, is required to
ensure proper airflow and allows enough room for easier
service.
Steps to Mount Plate

Mark all drill positions. At least 4 anchor holes are required, one at each perimeter corner of the plate. These are
needed to secure the plate, where the bold arrows are pointing, as shown in the picture above. Refer to the
specification sheet for unit weight so that enough anchors are installed at the proper locations.

Pre-drill guiding holes which are marked for anchors or screws on the wall.

Confirm the position of the holes and finish drilling to the depth required for anchors (NOT for screws).

Align the mounting plate holes with the holes drilled on the wall and put anchors or screws into the holes to
secure the mounting plate.
INSTALLATION OF INDOOR UNIT
DRILL 3 INCH HOLE FOR PIPING/WIRING/DRAIN
•
Locate the center where the hole will need to be drilled.
•
Drill the holes of 2.5
– 3 Inches in diameter. A down pitch of
about 1/4 inch per foot, as illustrated, is needed for the hole,
to drain the condensate properly.