MIN
I SPL
ITS
•
VRF
•
PTAC
•
SOLAR
•
LED
LIG
HT
IN
G
YMGI
Your Modern Green Idea
7
YMGI Group • 601 Arrow Ln, O’Fallon, MO 63366 • [email protected] • ymgigroup.com • 866-833-3138
Notes:
• Under 8°C heating function, fan speed is defaulted to auto speed and it cannot be adjusted.
• Under 8°C heating function, set temperature cannot be adjusted. Press “TURBO” button and the remote
controller won’t send signal.
• Sleep function and 8°C heating function can’t operate at the same time. If 8°C heating function has been
set under cooling mode, pressing the sleep button will cancel 8°C heating function. If sleep function has
been set under cooling mode, start up the 8°C heating function will cancel sleep function.
• Under °F temperature display, the remote controller will display 46°F heating.
Child Lock function
• Press “ “ or “ “ simultaneously to turn on or turn off child lock function. When child lock function is on,
“
“ icon is displayed on remote controller. If you operate the remote controller, the “
“ icon will blink
three times without sending signal to the unit.
Temperature display switchover function
In OFF status, press “ “ and “MODE” buttons simultaneously to change temperature display from °C and °F .
Operation Guide
1. After installation is complete, press “ON/OFF” button on remote controller to turn on the air conditioner.
2. Press “MODE” button to select your required mode: AUTO, COOL, DRY, FAN, HEAT.
3. Press “ “ or “ “ button to set your required temperature. (Temperature cannot be set in auto mode).
4. Press “FAN” button to set your required fan speed: auto, low, medium and high speed.
5. Press “SWING” button to select fan blowing angle
CHANGING BATTERIES AND NOTICES
1. Press slightly along the arrowhead direction to push the back cover open on the remote control.
2. Take out the old batteries. (As show in figure)
3. Insert two new AAA1.5V dry batteries, and pay attention to the polarity. (As show in figure)
4. Attach the back cover of wireless remote control. (As show in figure)
NOTE:
• During operation, point the remote control signal sender at the receiving window on indoor unit.
• The distance between signal sender and receiving window should be no more than 8m, and there should
be no obstacles between them.
• Signal may be interfered easily in the room where there is fluorescent lamp or wireless telephone; remote
controller should be close to indoor unit during operation.
• Replace new batteries of the same model when replacement is required.
• When you don’t use remote controller for a long time, please take out the batteries.
• If the display on remote controller is fuzzy or there’s no display, please replace batteries.
NOTE:
When changing the batteries, do not use the old or different batteries, otherwise, it can cause the remote control to malfunction. The
operation should be in its receiving range. It should be placed 36 inches away from a TV set or stereo. If the wireless remote control
cannot operate normally, please take the batteries out, wait 30 seconds and reinsert them. If the remote still doesn’t operate normally,
please change the batteries. If the wireless remote control will not be used for an extended period, it is recommended to remove the
batteries. Leaving the batteries in could cause them to leak. This will cause damage to the remote control.
