YitaHome CZWRL-V3, Руководство по сборке

Страница: 20 / 23

19
ASSEMBLY INSTRUCTIONS
14
1.Ensure the control knob is OFF then slowly open the
gas cylinder valve.
2.Press and turn the control knob to LIGHT. Push the igniter
to generate a spark while keeping the control knob pressed.
3.Check for the pilot flame through the glass tube. If the pilot
flame does not light , turn the control knob to the OFF position
and wait for at least two minutes then try again. Several
attempts may be necessary.
4.With the pilot light lit , keep the control knob pushed down
for 15 seconds then turn the control knob to LOW .
5.For maximum heat, turn the control knob to HIGH .
6.To turn the heater off, turn the control knob to OFF .
7.Close the valve on gas cylinder or regulator after use.
1.To enjoy outstanding heating performance for years , make sure to perform the following
maintenance activities on a regular basis:
● Keep exterior surfaces clean.
-Use warm soapy water for cleaning. Never use flammable
,
corrosive or abrasive cleaners.
-While washing your unit , be sure to keep the area around the burner and pilot assembly dry at all
time. If the gas control is exposed to water in any way , do NOT try to use it , and it must be replaced.
● After a long break from operation , the unit should be inspected for spiders , spider webs and
other insects.
● Air flow must be unobstructed. Keep controls , burner and circulating air passageways clean.
Signs of possible blockage include:
-Gas odor with extreme yellow flame tipping.
-Heater does NOT reach the desired temperature.
-Heater ’ s glow is excessively uneven.
-Heater makes popping noises.
● Spider and insects can nest in burner or orifices.
This dangerous situation can damage heater and render it unsafe for use.
Clean burner holes with a heavy-duty pipe cleaner.
Compressed air may help clear away smaller particles.
● Carbon deposits may create a fire hazard. Clean the inside of reflector and glass tube with
soapy water if any carbon deposits develop. Always be careful when cleaning the glass tube.
CLEANING AND MAINTENANCE:
OFF
LIGHT
LOW
HIGH
OFF
LO
HI