Y
ı
lmaz PVC ve Alm.
İş
leme Makineleri Ltd.
Ş
td
MK 420
41
7.3.7 After completing saw change raise the table a little bit. Push by hand table raising item (Figure 4 NO.94)
backwards and release from the groove, then lower the table slowly.
7.3.8 Fix the table by installing the pre-removed two pieces of M8 Imbus bolts (Figure 2 NO.93)
7.4 ANGULAR ADJUSMENT AND CORRECTNESS CONTROL OF SAW BLADE AND SET SQUARE
If you encounter problems during cutting operation (ie. Angular cutting)
7.4.1
Perform eye control to the run out of the blade. If possible with the help of a dial gauge.
7.4.2
If there exists problem during angular cutting, check the perpendiculartiy of the saw blade with the help of an
edge knife set square. If the perpendicularity is not correct,, loosen the handle nuts that fix the set square (fig2
no3) and nuts that fix the safety catch on the set square. (fig2 no2) Turn the set suare smoothly so that the
perpendicularity can be achieved according to the saw blade. After adjusting the perpendiculerity tighten the
handle.and place the safety catch to its position and tighten the nuts again.
7.5 ADJUST OF BELT TENSION
Adjusting of the belt tension, squeeze the screw shown in
PICTURE 5 till given dimension (20 mm). Check the tension
of the belt by pressing on the belt with your finger. Stretching
distance of the belt should be approximately 10 mm.
PICTURE 5