3. Preparations
In order to install the SuperGuard Vehicle Unit properly, the
following preparations should be carried out:
Prepare one operational GSM SIM card. Make sure that the SIM card
can operate without PIN protection (ask the GSM
operator to do this). Ask the GSM operator for the
SMSC (SMS Service Center) and Data Call (if
applicable) numbers.
Empty the SMS storage of the SIM card using
operational GSM phone (please refer your GSM phone
manual to do this).
Unscrew and remove the bottom cover of your Vehicle Unit.
Slide the SIM card into the SIM card holder as seen in the
picture below.
To connect the battery, securely plug the battery connector in
the connector on the board. This will power on the device, and
the green GSM LED will start flashing.
Replace back cover and secure with the screws.
Insert the SIM card
Connect the battery
to the board
4. Installation
The Vehicle Unit will only operate on 12V~24V systems with negative
earth (Negative to body).
o
Before starting installation, disconnect the vehicle battery and
observe other manufacturers safety instructions regarding
alarm systems, airbags or anti theft radio coding.
o
If you want to install the Vehicle Unit in the passenger
compartment, make sure that cables and wiring are protected
from sharp edges and is routed in such a manner that it will not
be pinched.
o
The EZT device should be mounted horizontally, and at a place
where the top side has an unobstructed view of the sky. The
ideal location is on top or directly under the dashboard plastic,
and close to the windshield. The device will not work if it is
placed beneath metal or metallic glass coatings.
o
Complete all electrical wiring and connections to the vehicle
before connecting the wire harnesses to the device.
7
NOTE:
Please note that installation methods may
vary between vehicle models. For expert wiring
and connecting please contact a professional car
electronics workshop for installation support and
maintenance.
