Yetter 2967-006A, Руководство оператора

Страница: 4 / 28

4
INTRODUCTION
The 2967-006 RESIDUE MANAGER
has been designed as a ‘universal’ fitment for several models of Kinze
Unit Mounted Coulters
– Planter Models 2000, 3000, 4900.
TABLE OF CONTENTS
Foreword .............................................................................................................................................. 2
Safety ................................................................................................................................................... 3
Torque Specifications ............................................................................................................................ 4
Image Identifications ......................................................................................................................... 5-7
Assembly Instructions ...................................................................................................................... 8-15
Operation ...................................................................................................................................... 16-18
Maintenance ...................................................................................................................................... 19
Part Identification .......................................................................................................................... 20-25
BOLT TORQUE
Before operating the 2967-006A Residue Manager for the first time, check to be sure that all hardware is tight. Check all hardware
again after approximately 50 hours of operation and at the beginning of each planting season.
All hardware used on the 2967-006A Residue Manager is Grade 5 unless otherwise noted. Grade 5 cap screws are marked with three
radial lines on the head. If hardware must be replaced, be sure to replace it with hardware of equal size, strength and thread type.
Refer to the torque values chart when tightening hardware.
Important: Over tightening hardware can cause as much damage as when under tightening. Tightening hardware beyond the
recommended range can reduce its shock load capacity.
The chart below is a guide for proper torque. Use it unless a specified torque is called out elsewhere in the manual.
Torque is the force you apply to the wrench handle or the cheater bar, times the length of the handle or bar.
Use a torque wrench whenever possible.
The following table shows torque in ft. lbs. for coarse thread hardware.
Lubricate all bearings and moving parts as assembled and make certain that they work freely.
WARNING: Never work around the toolbar/implement while in a raised position without using
safety lockups.
CAUTION: The 2967-006A Residue manager attachments are very heavy. Pay extra attention to
lifting techniques while handling and or maneuvering the opener during assembly. Failure to do so
may lead to personal injury.