Titlenames
16
assemblY
Assembly cont.
assemblY
dOGbOne attaChment Put a dab of Loc-tite onto
threads of a Yeti shoulder bolt (20). Thread bolt (20) and
washer (14) into other side of knuckle and tighten to 155 in/
lbs with a 5mm allen key. Use a second 5mm allen key to
hold the sleeve bolt (17) if necessary.
17
dOGbOne attaChment Slide air-valve end of shock
(3) into front triangle (1) knuckle pocket and line up
8mm bolt holes. Insert a 24.8mm sleeve bolt (17) into knuckle
from the left side of the bike and thru the shock (3) hole to
the other side of the knuckle.
16
dOGbOne attaChment With the insert (8) flush into
the other end of the dogbone (2), slide the dogbone (2)
between the front triangle (1) dogbone brackets mounted to
the top tube and line up the 8mm bolt holes while holding
spacers (21) in place. Insert a 24,8mm sleeve bolt (17)
into the bracket from the left side of the bike and thru the
dogbone insert (8) to the other side of the bracket.
18
ChainstaY attaChment Put a dab of Loc-tite onto
threads of a Yeti shoulder bolt (20). Thread bolt (20)
and washer (14) into other side of bracket and tighten to 115
in/lbs with a 5mm allen key. Use a second 5mm allen key
to hold the sleeve bolt (17) if necessary. If the black nylon
washers (11) have fallen off the Fox pin (10), then put them
back into place in preparation for installing the seatstay (4).
19
figure 6a: dogbone-shock (2-3) assembly
mounted to front triangle (1), exploded
figure 6b: dogbone-shock (2-3) assembly
mounted to front triangle (1), assembled
final assemblY While holding the black nylon
washers (11) in place, slide the upper seatstay (4) over
the washers (11) onto the Fox pin (10). This fit may be tight
and require that the seatstay (4) be worked back and forth to
get over the washers (11) and onto the Fox pin (10).
21
final assemblY Begin by attaching upper seatstay
(4) to the dogbone-shock (2-3). First, ensure the black
plastic washers (11) are placed on the ends of the Fox pin
(10). The washers (11) will have to be held in place by hand
when installing this part of the seatstay (4).
20
final assemblY Once onto the Fox pin (10), center
the 8mm thru holes and slide a 35.5mm Yeti sleeve bolt
(18) from the left side, thru the left side of the upper seatstay
(4), thru the Fox pin (10), and into the right side of the upper
seatstay (4).
22
final assemblY Put a dab of Loc-tite onto the
threads of a Yeti shoulder bolt (20) and insert the bolt
(20) and washer (14) into bolt (18) and tighten to 115 in/lbs
with a 5mm allen key. Use a second 5mm allen key to hold
the sleeve bolt (17) if necessary.
23
figure 7a: attached seatstay (4) to front
triangle (1), exploded
