Yeti ELECTRIC WING 46", Руководство пользователя

Страница: 8 / 12

40mm
Use a ruler to mark the positions of the horn, put the screws into the horns
so that the point of the screws stick through by approx 1mm. Push the
horn onto the elevon in the correct place and screw down. Align the horn
bottom plate up with the screws and re-tighten, do not over tighten, just
enough to grip the elevon firmly.
Switch on the radio system, neutralise all trims, check the horn is as
vertical as it will allow. Lay the model flat, the edge of the elevon should
be raised up 8mm from the surface. This is the neutral position.
Create a z-bend with pliers. Take off clevis attach z-bend and re-attach
clevis, adjust accordingly.
Installing the horns & pushrods.
SWITCH ON YOUR RADIO AND CANCEL ALL SUB TRIM
SET TRIMS TO NEUTRAL
Screw the screws into the horns so that the points of the
screws are just proud, Line up the horns as shown in FIG
5C, press down the horns, then screw them right down, get
the bottom part of the horn, align screws and screw down
until the horns grip the elevon, but not too tight.
Screw the clevises onto the pushrods halfway, attach the
clevis to the servo horn, Set the elevon position slightly
upwards as shown, mark the pushrod with a felt tip and
make your z-bend at this point. Note the horn holes may
need to be enlarged slightly,
Use a ruler to set neutral position
Z-Bend