Yeti ELECTRIC WING 46", Руководство пользователя

Страница: 7 / 12

TOP
TOP
3mm
2mm gap
2mm gap
You can make a hatches out of the
sheet of EPP foam supplied
Its time to put your servos back in. Find the holes you covered previously and
trim the tape away,
Seat the servos and use Cross weave tape to hold them in place, don’t forget to
put some coloured tape over to make it tidy.
Do the same for the servo cables, push them into the slot and re-cover
Pop the elevons out of the holder.
Cut some 50mm cross weave tape
down the middle to give you some
25mm lengths.
Run a strip of tape along the rear of
the wing, half on half off.
Attach the elevon, noting the 3mm
gap to the tip of the wing and the
2mm gap. Angle it down.
Turn the wing over and repeat, the
elevon should move quite freely up
and down