Yeti Cycles SB4.5, Руководство пользователя

Страница: 11 / 17

22. 23.
ASSEMBLY ASSEMBLY
Apply blue Loctite (242) to the threads of the
collet axle and a light amount of grease on the
shaft. Slip the link into place in the front triangle
and slide the collet axle through it to hold it in
place. Thread the axle into the keyed nut using a
5mm allen, but do not over tighten.
*Torque: 3Nm
Using a torque wrench with a 5mm allen, finish
tightening the lower link collet axle.
*Torque: 8Nm
05. 06.
08. 07.
Prep the inside of the collet axle and the threads
of the collet wedge bolt with grease. Using a
4mm allen, thread the collet wedge into the collet
axle. Finish with a torque wrench. Wipe up any
excess grease around the collet axle when done.
*Torque: 8Nm Prepare the swing arm by inserting the alloy
collet axle nuts in their corresponding insets and
peeling the blue protective film off of your chain-
suck protector.
Grease the main pivot collet axle shaft and
threads. Then, slide the main pivot into place.
Insert the main pivot collet axle. Use your guide
pin to help guide the axle through the bearing
spacer and bearings.
Using a 10mm allen, thread the collet axle into
the nut on the far side and hand tighten. Use a
torque wrench to finish tightening the collet axle.
*Torque: 3.5Nm
09. 10.
11. 12.
Apply a small amount of grease to the bearings
on the smaller end of the link to help hold the link
spacers in place while you install it. Place the keyed alloy collet axle nut into its
corresponding inset in the frame.