Yes Falcon-II, Руководство по эксплуатации, Страница: 14 / 20

14
5.2 DETAILED OPERATING INSTRUCTIONS
PowerOn
Press the Power button (
①)
to turn on the device after placing 4 AA batteries into
the battery holder or AC adapter plug into the DC socket . Once instrument has
been powered up, the CO2 reading will show after 15 seconds of warm up.
WarmUp
It takes approximately 1-minute before “WARM-UP” disappears from the LCD. All
the functions will not respond during the warm up period.
UserMode
After warm up, the device will stabilize and display the normal CO2 reading in the
upper part of the LCD) and remain visible at all times. Temperature and Ventilation
Rates will be shown in the lower portion of the LCD. The Up/Down button (
④/③)
allows you to scroll through the Temperature and Ventilation Modes. When pressing
the Up button, the lower display will go through the following sequence: “TempºC ->
TempºF -> Vent Rate lps -> Vent Rate cfm/p”.
NOTE: “lps” refers to Liter Per Second Per Person; “cfm/p” refers to Cubic Feet Per
Minute Per Person
5.22 OPERATION - MODE ADJUSTMENT
1.0 ALTI Mode
1.1. Press the Mode Button (
⑤),
“ALTI” flashes
1.2. Press Mode (
⑤)
to alter between “m” (meters) and “ft” (feet).
1.3. Press Up/Down (
④/③)
to adjust the altitude (Step=100m/500ft)
1.4. Press the Enter Button (
②),
save or leave the ALTI Mode, and return to User
Mode.
2.0 ALARM Mode
2.1. Adjust the alarm level
2.1.1. Press the Mode button (
⑤),
until ALARM flashes
2.1.2. Press the Enter Button (
②), “
CO2” icon flashes.
2.1.3. Press Up/Down (
④/③)
to adjust the alarm level (
≧
1,000 ppm, interval is
±
100ppm;
＜
1,000 ppm, interval is
±
50 ppm)
2.1.4. Press the Enter (
②),
save the setting and return to the User Mode.
2.2. Turn ON/OFF the ALARM
2.2.1. Press the Mode button (
⑤),
until “Speaker Icon” flashes
2.2.2. Press Enter Button (
②)
2.2.3. Press Up/Down (
④/③)
to turn the ALARM on or off
2.2.4. Press the Enter (
②),
save the setting and return to the User Mode.