yellow jacket CA502, Руководство пользователя и по обслуживанию

Страница: 17 / 68

17
To perform complete flue gas analysis, follow the instructions below.
SOME IMPORTANT WARNINGS TO CONSIDER DURING THE COMBUSTION ANALYSIS
ARE LISTED BELOW:
FOR CORRECT ANALYSIS NO AIR MUST FLOW INTO THE PIPE FROM OUTSIDE DUE TO
A BAD TIGHTENING OF THE POSITIONING CONE OR A LEAK IN THE PIPELINE.
THE GAS PIPE MUST BE CHECKED IN ORDER TO AVOID ANY LEAKS OR OBSTRUCTIONS ALONG
THE PATH. THE CONNECTORS OF THE GAS SAMPLING PROBE AND OF THE CONDENSATION FILTER
MUST BE WELL CONNECTED TO THE CA502. KEEP THE CONDENSATION TRAP IN A VERTICAL
POSITION DURING THE ANALYSIS. INCORRECT POSITIONING MAY CAUSE CONDENSATE TO GO IN
THE CA502 AND DAMAGE THE SENSORS. AFTER EACH ANALYSIS CHECK FOR ANY PRESENCE OF
WATER IN THE CONDENSATE COLLECTION BOWL AND REMOVE IT. PUT THE PROBE BACK IN THE
CASE ONLY AFTER YOU HAVE ELIMINATED CONDENSATE FROM THE TUBE AND THE EXPANSION
TANK (SEE CHAPTER ' MAINTENANCE '). REPLACE THE FINE DUST FILTER IF IT IS VISIBLY DIRTY OR
WET (SEE CHAPTER ' MAINTENANCE '). DO NOT PERFORM ANY MEASUREMENT WHEN THE FILTER IS
REMOVED OR DIRTY TO AVOID ANY RISK OF IRREVERSIBLE DAMAGES TO SENSORS AND
ANALYZER ITSELF.
8.0 FLUE GAS ANALYSIS
8.1 FLUE GAS ANALYSIS
11/12/17 10:00
AUTOZERO
Primary air
acquisition
T: 85.5°F
keep Repeat
11/12/17 10:00
AUTOZERO
60
Primary air
acquisition
Keep
pressed for a
few seconds
CA502
N.S.:0
Fw:1.00-EVAL03
BEFORE TURNING ON THE CA502:
•
CONNECT THE GAS SAMPLING PROBE TO THE DEVICE.
•
STORING OF THE AMBIENT TEMPERATURE: UPON COMPLETION OF THE AUTO ZERO
IN FRESH OUTDOOR AIR, PRESS THE “ KEEP ” BUTTON TO STORE THE OUTSIDE
TEMPERATURE BEING USED FOR PRIMARY AIR.
IF THE Tc - K CONNECTOR IS NOT PLUGGED IN, THE TEMPERATURE WILL NOT BE
CAPTURED.
8.1.1 Switching on the CA502 and auto - calibration
11/12/17 10:00
HARDWARE
►Memories KO
Calibration KO
voltages
ADC channels
WARNING!
When the CA502 is turned on, a hardware check is
performed on the memory and on the calibration. If an
error occurs, it will be shown with the activation of the
Hardware screen. In this case, it is advisable to
restart the CA502. If the problem keeps appearing or
becomes a frequent occurrence, please contact the
YELLOW JACKET
®
Service Center, communicating
the shown error.